Posypat Poštovní směrovací číslo sliz raft gap from model Dědic jídlo dobrovolník
Printing Without Rafts and Redesigned Interface in Z-SUITE 2.8.0 | Zortrax
Rafts, Skirts, and Brims Tutorial | Simplify3D
Too much gap between raft and model. - Ultimaker Cura - Ultimaker Community of 3D Printing Experts
Raft fail to print at gap layer. GCODE inspection looks similar - Troubleshooting - AstroPrint Forum
3D Printing Raft vs Brim vs Skirt: The Differences | All3DP
Build plate adhesion settings – Ultimaker Support
Odd gap between the raft and the print. This seems to happen only with some prints. The right side is better, but still lifts in some places while you can see the
Adding additional extrusion to a raft (raft with a skirt?) - 3D Printing Stack Exchange
Indian Head is the Place - Indian Head
3D Printer Supports vs. Rafts vs. Brims: What are they and when to use them? « Home 3D Print Guide
PVA raft + PVA supports results in the model being printed with an airgap of 1 layer instead of directly on PVA · Issue #6488 · Ultimaker/Cura · GitHub
Z-SUITE 2: Print Preparation Guide | Zortrax Support Center